Cleaning Filter Screen V1

3D Systems’ Infocenter Moves to Salesforce

The Infocenter has been the 3D Systems portal for customer-facing and service-facing product documentation (for example videos, software downloads, and material SDSs).  

As of Sept 26, 2022, the Infocenter content will be moved to Salesforce and will be accessible through the Salesforce Community https://support.3dsystems.com/s/.

Service Documentation Only

To access service documentation, you will need to sign into Salesforce Community using your Salesforce username and password. Everyone trained and currently authorized to service a particular printer will be able to access its service documentation.

If you have any issues or need assistance, please contact the infocenterhelp@3dsystems.com.

Cleaning Filter Screen (ProJet® MJP 2500W)

There is a screen that is placed above the particulate filter to add extra filtering protection for the filter. This screen will need to be checked or cleaned weekly.

  1. Open the compartment holding the filter screen by loosening the two thumb screws above the particulate filter compartment (1).

  1. Wearing Nitrile gloves, lift panel up and pull out screen.

  1. If more than 50% of the screen is blocked, clean the screen by holding over an approved waste disposal receptacle and brushing off loose particles from screen. Screen may then be wiped clean using a paper towel with water. 

  1. Close panel and tighten thumb screw.