LC-3DMixer

3D Systems’ Infocenter Moves to Salesforce

The Infocenter has been the 3D Systems portal for customer-facing and service-facing product documentation (for example videos, software downloads, and material SDSs).  

As of Sept 26, 2022, the Infocenter content will be moved to Salesforce and will be accessible through the Salesforce Community https://support.3dsystems.com/s/.

Service Documentation Only

To access service documentation, you will need to sign into Salesforce Community using your Salesforce username and password. Everyone trained and currently authorized to service a particular printer will be able to access its service documentation.

If you have any issues or need assistance, please contact the infocenterhelp@3dsystems.com.

Before pouring the resin in the resin tray, it is necessary to mix it before each use to obtain the best-possible chemical mixture in the bottle. The recommended method of mixing the resin is with the NextDent LC-3DMixer. This device is sold separately from the printer. With this mixer, you can roll two bottles at once for a specified period of time. For information on resin stirring times, please refer to the Resin Stirring and Curing Chart.

lc-3d-mixer.jpg lc-3d-mixer-back.jpg
LC-3DMixer front LC-3DMixer back

 

A Mixing Timer - Shows the duration of resin mixing
B Time Increase - Increases the duration of mixing
C Time Decrease - Decreases the duration of mixing
D Start/Stop Button - Starts and stops bottle mixing
E Bottle Rollers - Rest the material bottles in between each of the pairs of rollers (please see the image below)
F Power Button - Turns the mixer on and off
G Power Inlet - Plug the female end of the power cord into this inlet
H Device Label - Provides important information about the LC-3DMixer

 

bottle-mixer-with-bottles.jpg
LC-3DMixer bottle placement