1. User Guide
  2. Operation
  3. Prepare and Install the Resin Tray
  4. Install Resin Tray

Install Resin Tray

NOTE: A print platform should not be installed during this procedure.

CAUTION: If tension system is damaged in some way, do not attempt to force any components to engage/disengage. Doing so could further damage the tension system, as well as other parts of the printer. Contact 3D Systems Service immediately.

Wear 100% nitrile gloves whenever reaching inside the print chamber.

 

 

  1. Open the front door of the printer.
 
  1. Push in the tension-arm release lever on the front of the tension arm and lift up the tension arm. The arm will stay in place in the up position.

lift-tension-arm.gif
  1. Carefully lower the resin tray into place, concave side up, as seen at the right. It should fit snugly in the holder on the chassis.

bottom-of-print-tray.jpg

 install-resin-tray.gif
  1. Apply tension to the membrane by flipping down the manual tension arm until the release lever locks it in place.

CAUTION: Major build defects and/or membrane failure will result if a print is attempted on an untensioned membrane.
print-tray-orientation-v4.jpg