Pass Through Material Changeover (MCO)

The Pass Though Material Changeover gives the option for different rigid materials to be swapped out without performing a Material Changeover (MCO).

NOTE: Performing a Pass Through MCO will have some material mixing. This option is only applied to rigid materials.

1. When swapping to a different rigid material than what is currently installed, the message "Material Mismatch" will be displayed on the UI.

Select Material Changeover if you would like to have no mixing between materials. This option will perform a full MCO.

or

Select Begin using VisiJet M2 xxx. Materials will have some mixing.

or

Select Continue using VisiJet M2 xxx. Reinstall the currently used material.

Below is the Material Change Over (MCO) Matrix. This matrix shows the required action when switching materials.

F= Full MCO required

N= No MCO, print through okay 

F, N = Give the user the option to do a "Full MCO" or choose to just insert bottles and do "No MCO"