Add Cleaning Solution

To add Cleaning Solution, follow the steps below.

Note.png

NOTE: Wear protective gloves for the below procedure.

  1. Open the top cover and then open the Service Station cover.
  2. Hold down the top of the service station while pulling off the red cap.

IMG_3678.JPG

  1. Remove the red cap. Add Cleaning Solution until the tank is HALF full. Do not overfill.

43.jpg 44.jpg

  1. Replace the cap and close the Service Station cover.
  2. Reset the Maintenance Counter in 3D Print. See the 3DPrint Software Manual for details on how to do this. infocenter.3dsystems.com/projetcjpx60/3d-print™-software-user-guide