Add Binder

If there is not enough binder in one or more of the cartridges, 3DPrint displays BINDER LOW in the Printer Status dialog.

caution.png

Important: Do not add binder unless you are prompted to in the 3DPrint Printer Status dialog to avoid overfilling the reservoir.

To add binder, follow the steps below.

  1. Pull the empty binder cartridge out of its housing on the printer.
  2. Get a new binder cartridge. Check the expiration date, and check the cartridge label for the correct orientation.
  3. Insert the cartridge into its housing. Ensure the cartridge is pushed all the way in. You should feel it gently snap into place.
caution.png

Important: If a cartridge does not snap into place, do not force it. Check the orientation and that it is the correct type and try again.

 

39.jpg