Post Processing Using Salt Water Cure™

Salt Water Cure with Epsom salt is the best way to finish monochrome concept models quickly, easily and economically. No hazardous or restricted chemicals are involved; simply dissolve Epsom salt in warm water and it is ready to be misted over the surface of a part. Parts must then dry at room temperature for 24-48 hours, or can be speed dried with the use of an oven or hair dryer. This results in sufficient strength for safe handling as well as a smoother, harder surface finish. It also helps to maintain the part’s original bright white appearance.

Note: Salt Water cure is for monochrome (colorless) parts only.

For complete details on post processing with Salt Water Cure see the VisiJet PXL User Guide.