MiniBench provides an excellent grated surface to position printed parts for treatment with Colorbond. The table is designed with an internal fan and filter to reduce the Colorbond odor and to aid in the drying time of the part.
![]() |
NOTE: MiniBench should only be used in a well-ventilated room. |
![]() |
Safety glasses should always be worn when treating your parts with Colorbond. |
![]() |
WARNING: Safety gloves should always be worn when treating your parts with Colorbond. |
![]() |
CAUTION: Personal protective equipment (PPE) including the use of a respiratory mask and protective clothing is strongly recommended. |
![]() |
WARNING: When Colorbond penetrates a printed part, a chemical reaction will make the part's temperature increase. Exercise caution when adding Colorbond to your parts and handle them appropriately. |
![]() |
CAUTION: Dispose of all post-processing waste according to your local laws and statutes. |
![]() |
NOTE: The power switch is located on the right side of the table. |
![]() |
NOTE: The non-stick paper should be as large as the footprint of your part. Do not cover the entire top grate because that will prevent the internal fan from working as intended. |
![]() |
NOTE: For more information, refer to the section of this guide titled "Using Colorbond." |
![]() |
CAUTION: If any Colorbond spills onto the MiniBench, clean the spill with paper towels before the Colorbond can harden. |
The filter should be frequently checked and replaced when needed.