Tip: Wear gloves while dipping models to keep the bath clean and prevent mold growth.
- Gently submerse the part in the bath for at least 5-10 seconds or until bubbles subside.
- Slowly remove the part and hold it above the bath for 5-10 seconds to allow a majority of the excess water to run off. Rotate the part to help the water escape from any cavities or crevices.
- Move the part to the paper towels and gently dab the bottom of it on the dry paper towels.
Tip: Avoid wiping the excess water on the top surfaces with a paper towel as this will compromise surface finish.
- Place the dipped part on the wax paper and allow it to air dry for 1-2 hours before handling.
Tip: A fan or hair dryer can be used to harden the surface layers more rapidly. This allows for quicker handling. Note the parts may still be weak, so handle with care.