Setup - StrengthMax™ Large Bottles

Setup - StrengthMax™ Large Bottles

 

If using the StrengthMax™ large bottles, prepare them as follows:

  1. Locate plastic pumps and straws.
  2. Attach the long straw to one pump and screw the pump onto the Resin bottle. Tighten the upper cap against the lower cap.
  3. Holding the upper cap, unscrew the spout until it springs up into position.
  4. Attach the short straw to the other pump and screw the pump onto the Hardener bottle. Tighten the upper cap against the lower cap. Also unscrew its spout.
  5. Prime both pumps before measuring your first batch.
  6. Place the rubber caps over the pump nozzles between uses to prevent the pumps from drying out. Once the rubber caps are in use do not swap them or you may bond the caps to the nozzles.
  IMG_4032.JPG

 

Nozzle 1.png