For each dental indication that can be printed on the NextDent 5100, part orientation in the part-preparation software is key. This section provides a quick reference for the best ways to orient parts in 3D Sprint for any print material available for the NextDent 5100. This will help ensure build success and maximum usage of the printable area.
![]() |
CAUTION: Do not attempt to build any other dental indication with a resin other than what that resin is specifically prescribed for. For example, do not use Denture 3D+ to build crowns and bridges. Doing so will result in a failed build and the part that prints will not have any medical certification. |
Indication | Build File Orientation | Number of Units on 124 x 70 mm Print Platform |
---|---|---|
Denture 3D+ (60-70mm height) |
60° |
3-4 |
SG (Quarter, 24mm height) |
Horizontal |
6 |
C&B MFH (13mm height) |
45° |
~45 |
C&B MFH - Full Dental Arch |
Horizontal |
2 |
Ortho Rigid (14mm height) |
Horizontal |
2 |
Ortho IBT (11mm height) |
Horizontal |
2 |
Model 2.0 Prothsodontic (23mm height) |
Horizontal |
1-2 |
Model 2.0 Orthodontic |
Orthodontic "horseshoe" - Vertical Orthodontic full - Horizontal |
|
Model 2.0 Premium |
Premium |
|
Model 2.0 Ortho Stacked |
Ortho Stacked |
|
Tray (71mm height) |
Vertical |
3-4 |
Gingiva Mask |
Vertical |
~20 |
Cast - Coping (crown) (13mm height) |
45° |
~45 |
Cast - Replaceable Partial Denture (16mm height) |
Horizontal |
2-3 |
Try-In |
30° |
3-4 |