LC-3DMixer

Before pouring the resin in the resin tray, it is necessary to mix it before each use to obtain the best-possible chemical mixture in the bottle. The required method of mixing the resin is with the NextDent LC-3DMixer. This device is sold separately from the printer. With this mixer, you can roll two bottles at once for a specified period of time. For information on resin stirring times, please refer to the Resin Stirring and Curing Chart.

lc-3d-mixer.jpg lc-3d-mixer-back.jpg
LC-3DMixer front LC-3DMixer back

 

A Mixing Timer - Shows the duration of resin mixing
B Time Increase - Increases the duration of mixing
C Time Decrease - Decreases the duration of mixing
D Start/Stop Button - Starts and stops bottle mixing
E Bottle Rollers - Rest the material bottles in between each of the pairs of rollers (please see the image below)
F Power Button - Turns the mixer on and off
G Power Inlet - Plug the female end of the power cord into this inlet
H Device Label - Provides important information about the LC-3DMixer

 

bottle-mixer-with-bottles.jpg
LC-3DMixer bottle placement