Update Printer Firmware via 3D Sprint

Whenever you open 3D Sprint, as long as the NextDent 5100 is set as your default printer, the system will always check to see if your printer has the most up-to-date firmware. If the firmware is not up-to-date, Sprint will show you a popup prompt to update it. Click the button to update. If you choose to update the firmware at a later date, please close the popup and follow the instructions below when you are ready to update.

NOTE: Both your 3D Sprint computer and the printer must be on the same network to update the printer's firmware.

Click the Printer Tools button.
Click the Check for Updates button. This will either give you a popup to update the printer's firmware or a popup that will tell you that the printer's firmware is up to date.
If there is new firmware, click Yes to install.
Perform this update for all NextDent 5100 printers at your facility, as needed.