For each Figure 4 material, the Standard print mode in 3D Sprint is designed to give you accurate prints right out of the box. Please use the Standard print mode first and foremost to achieve part accuracy. However, if after measuring your parts you find that you have issues achieving accuracy, you may use the Accuracy Wizard in 3D Sprint to troubleshoot such issues.
Each Figure 4 Standalone printer will vary slightly in accuracy. If you have multiple printers, you will need to set the accuracy for each one separately. To do this, click the Printer icon in the upper left, select each printer one-by-one, and run the steps in this section for each. Additionally, you will need to run the wizard for each Material/Build Style combination you use.
NOTE: You will need calipers or a micrometer for this procedure to measure printed parts. Best Practices for using calipers on printed parts is demonstrated here (advance the video to 2:38). |
|
![]() |
||
|
![]() |
||
|
![]() |
||
|
![]() |
||
|
|||
|
![]() |
||
|
![]() |
||
|
|
||
|
![]() |
||
|
![]() |
||
|
![]() |
||
|
![]() |