You may clean the resin tray with >90% alcohol solvent between builds, enabling you to use different resins in the same resin tray (not at the same time). However, if a clear resin is poured into a tray that previously had a pigmented resin, it could result in undesirable coloring of the printed part. Because of this, if you intend to use the whole family of Figure 4 print materials, you will need a minimum of two resin trays for your Figure 4 Standalone Printer. The chart below shows which resins can share the same resin tray (provided that you have cleaned them with >90% alcohol solvent in between uses), with the minimum two trays indicated as trays 1 and 2. You may desire to use more than two trays for your purposes. Mark your resin trays with letters or numbers to help you remember which tray is which.
Tray 1 Figure 4 TOUGH GRY 10 Figure 4 TOUGH GRY 15 Figure 4 JCAST-GRN 10 Figure 4 ELAST-BLK 10 Figure 4 FLEX-BLK 10 Figure 4 TOUGH-BLK 20 Figure 4 PRO-BLK 10 Figure 4 HI TEMP 300-AMB Figure 4 FLEX-BLK 20 Figure 4 EGGSHELL-AMB 10 Figure 4 JewelMaster-GRY |
Tray 2 Figure 4 MED-AMB 10 Figure 4 MED-WHT 10 |
Tray 3 Figure 4 RUBBER-BLK 10 |