Resin Tray Material Cross-Usage

You may clean the resin tray with >90% alcohol solvent between builds, enabling you to use different resins in the same resin tray (not at the same time). However, if a clear resin is poured into a tray that previously had a pigmented resin, it could result in undesirable coloring of the printed part. Because of this, if you intend to use the whole family of Figure 4 print materials, you will need a minimum of two resin trays for your Figure 4 Standalone Printer. The chart below shows which resins can share the same resin tray (provided that you have cleaned them with >90% alcohol solvent in between uses), with the minimum two trays indicated as trays 1 and 2. You may desire to use more than two trays for your purposes. Mark your resin trays with letters or numbers to help you remember which tray is which.

Tray 1

Figure 4 TOUGH GRY 10

Figure 4 TOUGH GRY 15

Figure 4 JCAST-GRN 10

Figure 4 ELAST-BLK 10

Figure 4 FLEX-BLK 10

Figure 4 TOUGH-BLK 20

Figure 4 PRO-BLK 10

Figure 4 HI TEMP 300-AMB

Figure 4 FLEX-BLK 20

Figure 4 EGGSHELL-AMB 10

Tray 2

Figure 4 MED-AMB 10

Figure 4 MED-WHT 10

Tray 3

Figure 4 RUBBER-BLK 10