Frequency: | Every 3 months, or when prompted by touch screen |
The printer software will alert you periodically to replace the air filter, located on the back of the lower build chamber. A fan inside the printer pulls air in to cool off the printer components. This filter keeps contaminants out of the air being pulled in. If the filter gets resin on it, it must be replaced IMMEDIATELY.
![]() |
CAUTION: If you need to move the printer to perform this procedure, you must remove the resin tray and place it in its garage before beginning. Also, you will need to lift all leveling feet to move the printer and will need to re-level the printer once this procedure is done. |
![]() |
CAUTION: Failure to change the filter when prompted could lead to a clogged filter, which would block the cooling fan from taking in air. This could cause printer parts to overheat and fail. Similarly, installing a damaged or used air filter may result in overhearing or debris getting in the lower print chamber. |
|
![]() |
|
![]() |
|
|
|
![]() |