Install 3D Sprint Software

NOTE: 3D Sprint software is always subject to updates. An announcement, along with release notes, will accompany a new software-version release.

Please see the Software Downloads page for information on downloading/installing 3D Sprint. Before installing 3D Sprint, you may have to update some settings on your computer and graphics card. Please read the 3D Sprint Installation Guide for procedures on this and for full installation instructions.

Set Up Printer On Network

An offline setup for your printer is also available. Contact your reseller for more information. Follow the instructions below to set up your printer on your network.

Open 3D Sprint.
If the Printer dialog box is not already open, click the icon in the upper-left-hand corner (1).
In the Printer dialog box, click the Find Printer button (2). 3D Sprint should find your printer on the network. If this does NOT happen, enter your printer's IP address in the Find by printer IP field (3) and press Enter.The printer's IP address can be found on the printer's touch screen by going to the Settings tab (see below).
Click the Figure 4 Standalone icon (4). Click Next (5).

NOTE: You must make the printer's IP address an exception on your network's firewall.

Click the icon of the print material you will use in your build. Click Next.

Click the icon of the print mode you will use in your build. Click Next.

Click the icon of the build style you will use in your build. Click Set.

Install 3D Sprint Software

Set Up Printer On Network

SOLUTIONS

RESOURCES

SERVICE SUPPORT

HOW TO BUY

ABOUT US