Leveling Feet

The Printer has four casters with leveling feet. Only 3D Systems Certified Service Personnel may adjust these leveling feet.

CAUTION: Adjusting the leveling feet improperly can result in variable resin height in the resin tray, which can cause a degradation in print quality due to variable resin flow under the part.

 

caster-overview.jpg
A Caster - The four casters allow the Printer to roll along a level surface during printer installation.
B Locking Nut - Secures the Leveling Foot in place once desired level has been achieved during Printer installation.
C Adjustment Nut - The 3D Systems installer uses this nut to adjust the Leveling Foot up and down.
D Leveling Foot - Adjustable foot on each of the bottom-four corners of the Printer