In general, you will not be using a resin tray on a Printer other than the one it was originally installed on. However, there may be some cases in which you might need to move a resin tray to another Printer. If you do this, even if you clean the resin tray thoroughly after removal, residual elements of the previous print material cannot be reliably fully removed. Because of this, a resin tray may only be swapped with another compatible resin tray. The chart below shows which materials can share the same resin tray (not at the same time) after cleaning.
Figure 4 Resins
Tray 1 Figure 4 TOUGH GRY 10 Figure 4 TOUGH GRY 15 Figure 4 ELAST-BLK 10 Figure 4 FLEX-BLK 10 Figure 4 TOUGH-BLK 20 Figure 4 PRO-BLK 10 Figure 4 HI TEMP 300-AMB Figure 4 FLEX-BLK 20 Figure 4 EGGSHELL-AMB 10 |
Tray 2 Figure 4 MED-AMB 10 |
Tray 3 Figure 4 RUBBER-BLK 10 Figure 4 RUBBER-65A BLK |