Printer Statuses

print-mod-ready.jpg

A Printer may have one of the following statuses shown in the lower-left corner of the Status Card:

Ready - This status means that the printer operator has marked the Printer as "ready" and that all printer sensors that might hinder printing are satisfied.

Not Ready - This status means that the printer operator did not mark the Printer as "ready," and/or that one or more printer sensors that might hinder printing is not satisfied.

Printing - This status means that the Printer is currently printing.

Aborted - This status means that the most-recent print job was aborted.

Completed - This status means that most-recent print job has finished building.

Untensioned - This status means that the tension arms are not engaged on the resin tray.

Disconnected - This status means that the printer cannot connect to the Controller for some reason. Please see item 8 in the Error Message Glossary for more information.

Disabled - This status means that the printer has been disabled via the Printer Info. Card. It cannot accept a print job in this state.

Failed - This status means that the most-recent build has failed.

Low Air Pressure - This status means that there is a pressure loss in the pneumatic system. Please see item 14 in the Error Message Glossary for more information.

MCO In Progress - This status means that the operator is currently performing a Material Changeover procedure.

 

There could also be symbols accompanying some statuses:

red-exclamantion-symbol.jpg Indicates a printer error that will prevent it from printing and requires immediate attention
yellow-exclamantion-symbol.jpg Indicates a warning of a printer condition that will prevent it from printing, but does not need immediate attention