Once your Figure 4 Modular parts have printed, they are considered "green." That is to say that they are not finished parts yet, and are not safe to touch without 100% nitrile gloves. The parts will not be considered finished and safe to touch until they have been properly cleaned, dried, and fully cured in a UV chamber. The purpose of this manual is to guide you in the proper Post-Processing of your Modular parts.
The instructions in this guide are only meant to be applied to those resins that are available for the Figure 4 Modular 3D printer system. The currently available resins are listed below:
Figure 4 TOUGH-GRY 10
Figure 4 TOUGH-GRY 15
Figure 4 ELAST-BLK 10
Figure 4 FLEX-BLK 10
Figure 4 MED-AMB 10
Figure 4 TOUGH-BLK 20
Figure 4 PRO-BLK 10
Figure 4 HI TEMP 300-AMB
Figure 4 RUBBER-BLK 10
Figure 4 FLEX-BLK 20
Figure 4 EGGSHELL-AMB 10