Prior to Usage

Prior to using the Figure 4 UV Curing Unit 350, ensure you have completed the following post-processing steps, as seen in your printer's Post-Processing Guide:

  • Clean the part with the recommended method and solvents
  • Completely dry the part
  • If curing on the glass plates, remove all supporting architecture from the parts before placing them in the machine. Supports will be significantly harder to remove if they are cured on the part.

CAUTION: Failure to complete any of these steps before placing parts in the UV Curing Unit 350 risks under-cured and/or warped parts.

 

Additional Documentation

Ensure you have read your printer's Post-Processing Guide, and your resin's User Guide. Both guides contain the recommended, tested curing times for Figure 4 resins.