Introduction

This guide provides you with information on how to properly prepare your facility for the Figure 4 Modular. This chapter introduces you to the Figure 4 Modular machine and other system components — including lists of other support equipment and supplies that you will find helpful in setting up your facility.

Additional chapters include guidelines for the following:

  • Site Selection - gives information on how much space the Figure 4 Modular requires, and the necessary services and equipment needed for a highly efficient, ideal location for your Figure 4 Modular and its components.
  • System Delivery - provides information about preparing for the delivery of your Figure 4 Modular.
  • System Installation - explains the process of, and requirements for, installing the Figure 4 Modular in your facility.
  • Resin Storage and Safety - gives you guidelines for proper storage, handling, and safety for Figure 4 resins.
  • Third-Party Supplies and Equipment - provides a summary of the optional equipment and supplies that 3D Systems recommends for efficient and complete part building, post processing, and finishing.

Warranty/Disclaimer
The performance characteristics of these products may vary according to product application, operating conditions, material combined with, or with end use. No part of this publication may be reproduced in any form without written permission from 3D Systems.

Limitation of Liability
In no event will 3D Systems™ be liable for any damages, including lost profits, cost of cover or other special, incidental, consequential or indirect damages arising from the use of this document, however caused by any theory of liability. This limitation will apply even if 3D Systems or an authorized dealer has been advised of the possibility of such damage. The document, in whole or in part, may be changed or modified at any time at the sole discretion of 3D Systems.

Copyright and Corporate Identity

©   3D Systems, Inc. Figure 4® with regard to printers is a registered trademark of 3D Systems. Figure 4™ with regard to resins is a trademark of 3D Systems.