The following items and accessories are contained in the printer package.
Figure 4 Jewelry Printer (pedestal optional) | ![]() |
Resin Tray - Contains the print material during part building. | ![]() |
Print Platform (x2) - The 3D-printed part adheres to the print platform during part building. | ![]() |
Catch Tray - Prevents print-material spills from entering the lower build chamber, should the resin-tray membrane be punctured. This comes installed in the printer. | ![]() |
Power Cord (country specific) - To connect printer to power source. The power cord has been packaged with your printer by your reseller to ensure you receive the correct power cord for your region. | ![]() |
Resin Mixer - Used to mix the Figure 4 print material while in the resin tray | ![]() |
Punch Tool - Used to remove the printed part from the print platform from underneath, and to clear the print-platform holes of partially cured print material. | ![]() |
Carbon Filter - Prevents print-material fumes from exiting the process chamber. You will install this in the Carbon-Filter Bracket, as seen below. |
![]() |
Resin Tray Garage - Used to cover a material-filled resin tray inside or outside the printer, so as to protect it from UV-light exposure and external contaminants | ![]() |
Platform Scraper - Used to scrape any residual partially cured material off the print platform | ![]() |
Intake Filter - Keeps dust out of the printer while feeding air to the cooling fan | ![]() |
Bubble Level - Used to level the printer | ![]() |
Part-Cleaning Brush - Used to aid in cleaning partially cured material off the print platform and printed part | ![]() |
Platform-Cleaning Fixture - Used to hold the print platform in a tub of solvent during platform cleaning | ![]() |
Ethernet Cable | ![]() |
Wire Brush - Used to help clean print platforms that have stuck-on, partially cured print material | ![]() |