1. User Guide
  2. Post Processing
  3. Remove Printed Parts From Platform

Remove Printed Parts From Platform

You must now remove the printed part(s) from the print platform to prepare them for cleaning.

WEAR 100% nitrile gloves whenever handling uncured or partially cured print material.

CAUTION: Ensure that any tools you use in post-processing have been cleaned since their last use.

 

  1. Put a nonabrasive cloth/lint-free paper towel underneath the print platform. Using the included punch tool, remove printed part from the print platform by pushing on it through the top side of the platform. Hold it the way you would a rubber stamp.

hole-puncher-hero.gif
  1. Once the parts are off the platform, rinse them in IPA by hand, holding them over a container that can catch the solvent.
 rinse-parts-off-platform.gif