Before pouring the print material in the resin tray, it is necessary to mix it before each use to obtain the best-possible chemical mixture in the bottle. The recommended method of mixing the material is with the NextDent LC-3DMixer. This device is sold separately from the printer. With this mixer, you can roll two bottles at once for a specified period of time. For information on material stirring times, please refer to the Material Stirring and Curing Chart.
![]() |
![]() |
LC-3DMixer front | LC-3DMixer back |
A | Mixing Timer - Shows the duration of resin mixing |
B | Time Increase - Increases the duration of mixing |
C | Time Decrease - Decreases the duration of mixing |
D | Start/Stop Button - Starts and stops bottle mixing |
E | Bottle Rollers - Rest the material bottles in between each of the pairs of rollers (see the image below) |
F | Power Button - Turns the mixer on and off |
G | Power Inlet - Plug the female end of the power cord into this inlet |
H | Device Label - Provides important information about the LC-3DMixer |
![]() |
LC-3DMixer bottle placement |