Physical Steps to Change Print Material

The Figure 4 Jewelry can print with all Figure 4 Jewelry print materials. Please see the section Print Material Bottles for a full list of supported materials. This section describes the steps that are necessary to cease using one material type in the printer, and to begin using another material type. You should have already scanned the new material into the printer's memory in the previous section.

  1. Remove the print platform and resin tray, cleaning them both, as per the sections Clean Print Platform and Clean Resin Tray.

scrape-supports-(2).jpg

  1. If the catch-tray glass has a large amount of spilled material on it, you must dispose of it according to all government regulations and replace it with a new catch tray. If it has no material, or just a few material spots on it, clean the glass with IPA on a nonabrasive cloth, according to the section Clean/Replace the Catch Tray.
remove-catch-tray.jpg
  1. Reinstall the print platform.
print-plat-in-machine-cu.jpg
  1. Either install a new resin tray or reinstall the cleaned old one, as per the section Install Resin Tray.
label-print-tray-2.png

You are now ready to perform the print process with a new print material.