Published on Figure 4 - Jewelry (http://infocenter.3dsystems.com/figure4jewelry)

Home > User Guide > Preventative Maintenance > Cleaning the Printer > Clean Tension System

Clean Tension System

Frequency: Monthly

You must periodically clean the tension latches on the left and right sides of the chassis.

WEAR 100% nitrile gloves throughout this procedure.

 

  1. Untension the resin tray and carefully remove it. Place it in the resin-tray garage with the lid on.

print-tray-garage-v2.jpg

 release-manual-tension-arm-v9.gif
  1. Remove both vanity covers from the printer chassis. Clean the vanity covers with a nonabrasive cloth and IPA.
 remove-vanity-covers.jpg
  1. Pour IPA on a nonabrasive cloth. Clean both latches and inspect them for any signs of damage. If there is damage, contact 3D Systems Service.
 clean-tension-latches-1.jpg
  1. Clean the top and bottom of the tension arm itself with IPA. Inspect the tension arm for any signs of damage. If there is damage, contact your reseller.
  2. Reinstall the vanity covers over the chassis.
 top-and-bottom-tension-arm.jpg

Cleaning of the tension system is now complete.

SOLUTIONS

RESOURCES

SERVICE SUPPORT

HOW TO BUY

ABOUT US

Connect with us:
Privacy Policy
Sales Terms
Terms and Conditions
Copyright ⓒ   3D Systems, Inc. All rights reserved.
var d = new Date(); document.getElementById("year").innerHTML = d.getFullYear();
Copyright © 3D Systems, Inc. All rights reserved. | Source URL: http://infocenter.3dsystems.com/figure4jewelry/user-guide/preventative-maintenance/cleaning-printer/clean-tension-system