Install Print Platform

 

Always wear nitrile gloves when handling the print Platform, as it could have uncured material on it that could irritate the skin.

NOTE: Before performing this procedure, ensure that elevator is at its upper limit, or offload, position.

 

  1. Install the print platform in the machine, using the guides on either end of the elevator platform to guide the print platform into place.
remov-print-plat.png
  1. Push down the handle to lock the print platform in place.

    NOTE: The printer checks if the print platform is present and if the handle is locked down. The printer will not print unless both conditions are met. If either condition is not met, you will receive the error message below before the print process begins.

    platform-not-detected.jpg

    CAUTION: Do NOT lift up the locking handle during printing. Doing so will abort the print job.

lock-print-plat.png