Tilt Tray

tilt-tray.jpg

A Toggle Case Locks - These four locks keep the print tray in place during part building, and also tension the print-tray film over the glass print base. The male ends are on the tilt tray. The female ends of these locks are on the print tray.
B Top of Tilt-Tray Elevator - The tilt tray uses an elevator with a lead screw to control its motion. This block is the upper part of the elevator.
C Tilt-Tray Pivot Point - The point about which the tilt tray tilts
D Glass Print Base - Translucent plate that tensions the print-tray film from the film's underside. The tilt tray has a raised holder to set the glass print base on.
E View Box - Hole in the tilt tray that allows UV radiation through