Before pouring the material in the print tray, it is necessary to mix it before each use to obtain the best-possible chemical mixture in the bottle. The recommended method of stirring the material is with the NextDent® LC-3DMixer. With this mixer, you can roll two bottles at once for a specified period of time. For information on material stirring times, please refer to the Material Stirring and Curing Chart.

lc-3d-mixer.jpg lc-3d-mixer-back.jpg
LC-3DMixer front LC-3DMixer back


A Mixing Timer - Shows the duration of material mixing
B Time Increase - Increases the duration of mixing
C Time Decrease - Decreases the duration of mixing
D Start/Stop Button - Starts and stops bottle mixing
E Bottle Rollers - Rest the material bottles in between each of the pairs of rollers (please see the image below)
F Power Button - Turns the mixer on and off
G Power Inlet - Plug the female end of the power cord into this inlet
H Device Label - Provides important information about the LC-3DMixer


LC-3DMixer bottle placement