Third-Party Supplies and Equipment

3D Systems™ provides this partial list of equipment and supplies/accessories that are useful for handling, processing or finishing FabPro parts. You should keep a list of preferred vendors for any 3D-print-related products you may order. Equipment and supplies are not limited to this list, as you may find other products and methods that more suit your needs.

NOTE: Customers are responsible for consulting local health, safety, and environmental regulations to determine additional site requirements. No information that is contained in this document constitutes legal advice regarding such requirements. 3D Systems™ has no responsibility to determine whether or not the customer is in compliance with applicable laws, nor do we guarantee the accuracy or quality of the supplier product.


Uninterruptible Power Supply (UPS) - While a UPS is not required for use with the printer, you may wish to use one for battery backup of your printer in the case of a power surge or outage.

UV Filter Screens - While these are not required, you may need to install filters over windows and lights so as not to cure any exposed print material before printing.

Disposable Lint-Free Paper Towels - You will use lint-free paper towels for assisting in cleaning printed parts, printer components, and material spills.

CAUTION: It is necessary to use lint-free paper towels, as lint from other types of paper towels can stick on the printed part or printer component. Lint on the printed part can cause improper final part curing in the UV oven. Lint on printer components can contaminate the material on the print platform and in the print tray, causing the printed part to lose accuracy or causing a build to crash.

Cellulose Wadding - This absorbent material is useful for covering your FabPro workbench, as well as for absorbing solvents during air drying of printed parts.

Chemically Resistant Gloves - 3D Systems recommends the use of 100% nitrile gloves whenever handling uncured material, partially cured printed parts, and solvents.

Eye-Wash Station - This may be designed specifically for eye-washing or may be an adapter that fits onto an existing faucet.

Fire Extinguisher - NFPA Class B such as CO2, dry-chemical, or foam

Hazardous-Materials Waste Can - While it is optional to get a fire-proof waste can, you must have a waste can approved to contain FabPro/NextDent materials, according to all local, state, and federal regulations.

Storage Cabinet - This is for storing material bottles and other FabPro-related equipment. You may choose to get a fire-proof cabinet; but it is not required to be fire-proof.

Lab Coats - Optional measure to protect your clothes/skin from uncured print material and solvents.

Neoprene-Coated Gloves - If you choose to use TPM as your cleaning solvent, these gloves are recommended for handling the chemical.

Cleaning Solvent - Cleaning solvents are used in cleaning printed parts, printer components, and areas where material has spilled. Please refer the Cleaning Chart to determine which solvent(s) to order.

Safety Glasses (405 nm radiation blocking) with side shielding - The printer operator should not be exposed to hazardous radiation from the printer or curing oven. However, in the case of an emergency where radiation emits from these devices, it is recommended to wear eye protection.

NextDent® LC-3DPrint Box - Please see the section LC-3DPrint Box for more information.

NextDent® LC-3DMixer - Please see the section LC-3DMixer for more information.

Ultrasonic Cleaner - Used to clean excess liquid material off the printed part before final UV curing. Order this from your local supply house.