Installation of your system encompasses three separate steps:
Please see the section Unpacking the printer.
In preparing your facility for FabPro system placement, you must consider three main factors:
Most standard doorways and hallways provide adequate access for moving the system. Each doorway and hallway must be wide enough to move and turn a box measuring 62 x 62 x 101 cm (24.5 x 24.5 x 39.75 in), while also allowing room for the people carrying it. Determine the pathway from where you will receive the boxed components to where your FabPro system will be installed. Walk this path, and measure any critical doorways or passageways to ensure that the equipment can be moved through the area. If a passageway or doorway is too small for the boxed FabPro system, it may be necessary to remove the FabPro system from its box before moving the unit. Since the printer is only 61.2 cm (24.1 in) high, the height limitations of most any door will not be an issue.