1. CubePro User Guide
  2. Maintenance
  3. Updating The Printer Firmware

Updating The Printer Firmware

The CubePro firmware can either be updated via wireless connection or by using a USB mass storage device. When using a USB mass storage device to update the firmware, go to www.3DSystems.com/shop/cubepro/downloads and download the latest firmware to your device.

Updating Firmware Using USB

  1. Select SETUP.

  1. Navigate to the Advanced screen and select FIRMWARE.

  1. Select USB KEY.

  1. Insert the USB mass storage device into the USB port and select the checkmark.

NOTE: The printer will search for new firmware.

NOTE: Wait until the update has been completed.

WARNING: DO NOT POWER OFF OR DISCONNECT THE PRINTER FROM UTILITY POWER DURING THE UPDATE PROCESS.

  1. Press and release the touchscreen display ON/OFF button and the display will restart.

Updating Firmware Using WI-FI

To update the firmware using the wireless utility, the printer must be connected to a wireless network.

  1. Select SETUP.

  1. Navigate to the Advanced screen and select FIRMWARE.

  1. Select WIFI.

NOTE: The printer will attempt to connect to the server.

NOTE: If the printer can not connect to the server, select RETRY to connect to the server. Select CANCEL if you do not want to update the firmware.

NOTE: The printer will check for a firmware update.

NOTE: The printer will begin downloading new firmware. The blue bar is also a progress indicator.

NOTE: The download could take a few minutes.

WARNING: DO NOT POWER OFF OR DISCONNECT THE PRINTER FROM UTILITY POWER DURING THE UPDATE PROCESS.

NOTE: If no new firmware is available, select the checkmark to continue.

NOTE: If the firmware download fails, select RETRY to start the download again. Select CANCEL if you do not want to update the firmware.

NOTE: The firmware will begin to install. The blue bar is also a progress indicator.

NOTE: This process could take a few minutes.

WARNING: DO NOT POWER OFF OR DISCONNECT THE PRINTER FROM UTILITY POWER DURING THE UPDATE PROCESS.

  1. Press and release the touchscreen display ON/OFF button and the display will restart.