Maintenance

General Cleaning

Waste material from the printing process can accumulate inside the printer. Using a slightly damp, lint-free cloth, wipe the interior of the CubePro including the print plate, the print pad, cartridge bays and anywhere else you might find pieces of plastic waste material.

RISK OF SHOCK: DO NOT WIPE DOWN ANY ELECTRICAL COMPONENTS. ALWAYS KEEP AWAY FROM ALL AREAS WHERE ELECTRONIC COMPONENTS ARE INSTALLED.

Cleaning The Jet Wiper

In addition to being a scraper for the print jets, the jet wiper assembly is also a refuse bin, collecting print material that has been primed from the print jets. As the jet wiper fills, it will need to be emptied regularly.

  1. With the print pad lowered, lift the jet wiper off the thumbscrew rest.

  1. Pull the jet wiper up and out to separate the mounting posts from the keyhole slots.

  1. Remove the jet wiper assembly from the printer.
  2. Remove the waste material from the jet wiper and then reinstall it in the CubePro. Refer to the section titled Unpacking And Initial Setup for more information about installing the jet wiper. Recycling information can be found in the section titled Cubify Sustainability Program.