Replacing A Material Cartridge

Replacing A Material Cartridge

Caution: Material cartridges should only be replaced by performing the following procedure. Replacing the cartridge without using the printer menu can damage the printer and print jets and void the manufacturer’s warranty.

  1. Select SETUP.

  1. Select CHANGE CARTRIDGE.

  1. Select the material cartridge to change.

NOTE: This procedure illustrates changing the right cartridge. The same concept applies to the left side.


NOTE: The print jet will begin to heat.


  1. When prompted, remove the right side cartridge. Select the checkmark to continue.

NOTE: Press the two cartridge tabs inward to release the cartridge from the printer.

CAUTION: The cartridge must be removed first before proceeding. Attempting to remove the print jet before being prompted to do so will damage the cartridge.

  1. Rotate the cartridge print jet counter-clockwise and remove the print jet from the printer. Select the checkmark to continue.

  1. Insert the cartridge print jet from the replacement cartridge into the print jet opening on top of the printer. 

  1. Rotate the cable clockwise until the dots align. Select the checkmark to continue.

NOTE: As the print jet is rotating, ensure the print jet tube is tucked under the top of the printer cover.

  1. Mount the new cartridge to the right side of the printer. Select the checkmark to continue.

NOTE: Ensure the print jet tube is tucked under the top of the printer cover.


NOTE: The print jet will begin to heat. Once the print jet has reached the proper temperature, the printer will prime melted material into the refuse bin.


  1. Select the checkmark to complete the procedure.