The printer firmware can either be updated via wireless connection or by using a USB mass storage device.
![]() |
NOTE: Whenever a firmware update is performed, you must perform the Auto Level and Auto Gap procedures. |
Updating Firmware Using Wi-Fi
- Select SETUP.
- Navigate to the System 3 screen and select FIRMWARE.
- Select WIFI.
![]() |
NOTE: The printer will attempt to connect to the server. |
![]() |
NOTE: If the printer can not connect to the server, select RETRY to connect to the server. Select CANCEL if you do not want to update the firmware. |
![]() |
NOTE: The printer will check for a firmware update. |
![]() |
NOTE: The printer will begin downloading new firmware. The blue bar is a progress indicator. |
![]() |
NOTE: The download could take a few minutes. |
![]() |
WARNING: DO NOT POWER OFF OR DISCONNECT THE PRINTER FROM UTILITY POWER DURING THE UPDATE PROCESS. |
![]() |
NOTE: If no new firmware is available, select the checkmark to continue. |
![]() |
NOTE: If the firmware download fails, select RETRY to start the download again. Select CANCEL if you do not want to update the firmware. |
![]() |
NOTE: The firmware will begin to install. The blue bar is a progress indicator. |
![]() |
NOTE: The installation could take a few minutes. |
![]() |
WARNING: DO NOT POWER OFF OR DISCONNECT THE PRINTER FROM UTILITY POWER DURING THE UPDATE PROCESS. |
- When prompted, press and release the power button and wait until the display turns on.
![]() |
NOTE: It may take a minute for the display to turn on. |
- Perform the Auto Level and Auto Gap procedures.
![]() |
NOTE: For more information, refer to the section titled Print Pad Calibration. |
Updating Firmware Using USB
When using a USB mass storage device to update the firmware, log in to your www.cubify.com account and download the latest firmware for your USB mass storage device.
- Select SETUP.
- Navigate to the System 3 screen and select FIRMWARE.
- Select USB KEY.
- Insert the USB mass storage device into the printer and select the checkmark to continue.
![]() |
NOTE: The printer will check for a firmware update. |
![]() |
NOTE: The printer will begin downloading new firmware. The blue bar is a progress indicator. |
![]() |
NOTE: The download could take a few minutes. |
![]() |
WARNING: DO NOT POWER OFF OR DISCONNECT THE PRINTER FROM UTILITY POWER DURING THE UPDATE PROCESS. |
![]() |
NOTE: If no new firmware is available, select the checkmark to continue. |
![]() |
NOTE: If the firmware download fails, select RETRY to start the download again. Select CANCEL if you do not want to update the firmware. |
![]() |
NOTE: The firmware will begin to install. The blue bar is a progress indicator. |
![]() |
NOTE: The installation could take a few minutes. |
![]() |
WARNING: DO NOT POWER OFF OR DISCONNECT THE PRINTER FROM UTILITY POWER DURING THE UPDATE PROCESS. |
- When prompted, press and release the power button and wait until the display turns on.
![]() |
NOTE: It may take a minute for the display to turn on. |
- Perform the Auto Level and Auto Gap procedures.
![]() |
NOTE: For more information, refer to the section titled Print Pad Calibration. |