Maintenance

General Cleaning

Waste material from the printing process can accumulate inside the printer. Using a slightly damp, lint-free cloth, wipe the interior of the Cube, including the print pad and anywhere else you might find pieces of plastic waste material. Print material can also collect around the belt area on the left side of the printer. This area should be checked periodically and any print material found should be removed.

Removing Waste From The Jet Wiper Purge Bins

In addition to having scrapers to clean the print jet nozzles, the jet wiper assemblies are also purge bins collecting print material that has been primed from the print jets. As the purge bin assemblies fill, they will need to be emptied regularly.

Handle
Jet wiper
Purge bin tab

Using the handle, pull the purge bin assembly inward at the top and then upward to free the bottom tab from the slot.

NOTE: Note the tab at the bottom of the purge bin. This tab is designed to fit into a slot for proper installation.

caution.png

CAUTION: When removing or installing the purge bin assemblies, be careful not to damage the bottom tabs. Ensure the purge bin assemblies are installed properly before using the printer.

Replacing The Jet Wipers

After a predetermined number of print jet cycles over the jet wipers the display will prompt the user to replace the wipers before printing another creation.

NOTE: When the left jet wiper has reached the end of its useful life, the printer will prompt you to replace it. Select the checkmark to continue.


NOTE: When the right jet wiper has reached the end of its useful life, the printer will prompt you to replace it. Select the checkmark to continue.

 


NOTE: If you have replaced the jet wiper, select the checkmark to reset the printer count. Press SKIP to be reminded later.


Procedure

  1. Remove the purge bin assemblies from the printer.

  1. Pull the jet wiper (A) upward.

  1. Install the new jet wiper onto the purge bin and reinstall the purge bin assembly into the printer.

NOTE: Ensure the jet wiper is fully seated before reinstalling the purge bin assembly.

  1. Select the checkmark to confirm the replacement of the jet wiper.