Important Safety Information

Safety Symbols and Definitions

Heat_sm-72.png

HOT SURFACE HAZARD: A HOT SURFACE IS ACCESSIBLE IN THE VICINITY OF THIS SIGN OR AT THE PRINT JET. AVOID CONTACT WITH THESE AREAS. HOT SURFACES CAN CAUSE SEVERE BURNS.

Caution_sm-72.png

Caution: Indicates something may happen that could cause loss of data, damage to equipment, or could cause personal injury.

Pinch_Point2_sm-72.png

Caution: Indicates a pinch point hazard that could cause personal injury.

Electrical_Shock_sm-36.png

SHOCK WARNING: INDICATES A POTENTIAL SHOCK HAZARD.

Safety Guidelines

  • Follow all safety rules in this section and observe all cautions and warnings in this guide.
  • DO NOT modify any safety features or make modifications to the Cube. Doing so is prohibited and voids the manufacturer’s warranty.
  • Use of print materials, or 3D prints other than 3D Systems’ print materials and genuine 3D Systems’ components may void the warranty.
  • Adult supervision is required; observe children closely and intervene as necessary to prevent potential safety problems and ensure the Cube’s appropriate use. Ensure small 3D prints are not accessible to young children. These 3D prints are potential choking hazards for young children.
  • DO NOT change a material cartridge during printing; doing so may damage the Cube.
Heat_sm-72.png

HOT SURFACE HAZARD: DO NOT TOUCH THE PRINT JETS DURING SETUP AND OPERATION. THE PRINT JETS BECOME VERY HOT.

Caution_sm-72.png

Caution: DO NOT disconnect the CUBE from utility power while the print jets are hot. Wait until the print jet’s amber light turns off before disconnecting from utility power as this may damage the print jet.

Caution_sm-72.png

Caution: Read and follow all instructions prior to setting up the printer.

Electrical_Shock_sm-36.png

SHOCK WARNING: DUE TO RISK OF SHOCK, AVOID CONTACT WITH ALL INTERNAL ELECTRONIC COMPONENTS.

Caution_sm-72.png

WARNING: THE CUBE SHOULD ONLY BE SERVICED BY AUTHORIZED SERVICE TECHNICIANS. PRIOR TO ANY PART REPLACEMENT PROCEDURE, THE PRINTER MUST BE POWERED OFF AND DISCONNECTED FROM UTILITY POWER.

Pinch_Point2_sm-72.png

WARNING: HAZARDOUS MOVING PARTS. KEEP FINGERS AND OTHER BODY PARTS AWAY.

To ensure safety, please exercise caution when operating your Cube. Read and follow all safety precautions as outlined in this user guide. Be careful when operating your Cube 3D Printer to ensure proper printing and be mindful of and avoid hot surfaces.