Accessories | Brill 3D Culinary Studio

Brill 3D Culinary Finishing Station - Use this to remove excess powder off your completed parts. This required peripheral is not included with the printer shipment and must be purchased separately.
Brill 3D Culinary Binder - Binder comes in 1 qt (0.9 L) bottles. Binders come in Clear, Red, Blue, and Yellow. These are not included with your printer shipment and must be purchased separately.
Brill 3D Culinary Powder - Powder comes in 25 lbs. (11.3 kg) pails. These are not included with your printer shipment and must be ordered separately.
Food-Safe Sanitizer - A sanitizer you will mix with water to clean key components of the printer. This is not included with your printer shipment and must be ordered separately.
Brill 3D Cleaning Solution - A cleaning solution used exclusively for the In-Place-Cleaning procedure. This is not included with your printer shipment and must be ordered separately.
Printhead Cleaning Guide with Lint-free Cloths - When Soaking the Printhead, the cleaning guide is used to protect the printhead jets; and the lint-free cloths must be used to clean the printhead. This is included with your printer shipment.
Printhead Inspection Mirror - Used to inspect the bottom of the printhead for binder residue during the Soak Printhead procedure. This is included with your printer shipment.
Food-Safe Grease - Used for lubricating the piston on the Printhead Station and the gantry rails. This is included with your printer shipment.
Grease Gun - Used for lubricating the gantry rails
Build Plate - Allows for the bulk removal of a print job, and transfer to the finishing station with minimal part handling. This accessory is recommended for large and/or delicate parts. This is included with your printer shipment.
Tamper - Use this to pack down powder in the Feed/Build bins during print preparation. This is included with your printer shipment.
Air Filter (installed in printer) - Decontaminates the air coming into the printer through the intake fan. This is included with your printer shipment.
48 in. (122 cm) Feed/Build Bin Vent-Cleaning Brush - Use this to clean the air vents associated with each powder bin. This is included with your printer shipment.
24 in. (61 cm) Printhead Station Drain-Cleaning Brush - Use this to clean the drainage tube in the Printhead Station. This is included with your printer shipment.
Flammable-Waste Can - Use this to dispose of waste/expired binder. This is not included with your printer shipment and must be ordered separately. Please refer to the binder SDS for additional guidance on disposal.	This image is for example purposes only and is not a recommendation or endorsement of any brand of flammable-waste container.

Printer-friendly version

Printer-friendly version