Update Printer Firmware via 3D Sprint

Whenever you open 3D Sprint, as long as the Brill 3D Culinary Printer is set as your default printer, the system will always check to see if your printer has the most up-to-date firmware. If the firmware is not up-to-date, Sprint will show you a popup prompt to update it. Click the button to update, and the update file will be sent to the connected printer; then follow Steps 4-6 below. If you choose to update the firmware at a later date, please close the popup and follow the instructions below when you are ready to update.

 

NOTE: Both your 3D Sprint computer and the printer must be on the same network to update the printer's firmware using this method. The update cannot be installed during printing.

 

  1. Click the Printer Tools button.
sprint printer tools btn.jpg
  1. Click the Check for Updates button. This will either give you a popup to update the printer's firmware or a popup that will tell you that the printer's firmware is up to date.
sprint check for updates btn.jpg
  1. If there is new firmware, click Yes to install and the update will be sent to your printer.
nextdent-update-fw-sprint.jpg
  1. On the printer, you will see the screen at the right. Tap Install Update to begin the update. If you tap Not Now, you will need to repeat Steps 1-3 again to resend the update to the printer, as the update file will not stay in the printer's memory.
install-fw-update.jpg
  1. Once the update is complete, you will see the screen at the right. Tap the X to exit the dialog.
fw-update-complete.jpg
  1. Go to Settings > Printer Info to confirm that the firmware version has updated to the version sent from 3D Sprint.
firmware-version-no.jpg