Electrical Safety

The Finishing Station was designed to minimize operator exposure to electrical hazards during normal operations. Do not remove any panels or other parts of the Finishing Station casing. All exposed electrical circuits are contained within limited-access cabinets. This is to separate the operator from service and maintenance areas. Only Certified Service Personnel should access the electrical panels. 120 VAC power is present in multiple locations throughout the machine. Whenever performing maintenance procedures, power down and unplug the machine if possible. Electrical power for the Finishing Station must be on a circuit that is protected by an overcurrent protection UL 489 listed-certified as “branch type”. If finishing station is connected to a circuit protected by fuses, use a time-delay fuse marked D.