Equipment Required
- Appropriately sized 3D Systems Post Curing Unit.
- 100 -200 Watt UV SPOT Curing Light (320nM-500)
- Third-Party Centrifuge – We recommend the Dadant M00452-S 62 in. or equivalent unit.
![]() |
NOTE: A height extension upgrade offered by Dadant is recommended for larger platform sizes. |
- Automotive vacuum pump shown below or similar.
Tool/Supplies Required
- Proper PPE (e.g. UV safety glasses, nitrile gloves, lab coat)
- Paper towels
- Isopropyl alcohol (IPA) 99%
- Respirator or down draft table (for sanding parts)
- Sanding block
- 80-150 grit sandpaper
![]() |
Note: Do not use a lower value of 99% Isopropyl alcohol. A lower percent contains more water which is not ideal for casting patterns. |