Figure 4™ TOUGH-GRY 15 is designed to offer high strength and stability for production applications. Economical pricing allows short run production parts to be produced at a fraction of the cost of traditional methods. With 35% elongation at break, this durable opaque gray material produces highly accurate components for consumer goods, aerospace and automotive industries, with digital molding productivity and cost-efficiency.
Accuracy Tips
In order to achieve good accuracy with TOUGH-GRY 15, it is important to follow the part setup instructions below for orientation and supports. Some other key tips are as follows:
- General best practices apply, as seen in the Figure 4 Print Material Quick Reference.
- For best results use the Resin Mixer to gently stir between prints and after the resin has been sitting overnight.
CAUTION: Do NOT press down on the film when stirring.
Orientation
Please see Orientation section for TOUGH-GRY 10.
General Flat Tip Supports
Please see General Flat Tip Supports section for TOUGH-GRY 10.
- Best for general use for fine small parts up to large and large-cover parts.
- General Round Tip - Best for Standard Thick build style, when reliability is a must, such as tensile bars and accuracy blocks.
Fine Flat Tip Supports
Please see Fine Flat Tip Supports section for TOUGH-GRY 10.
Best for large thin parts or small fine feature parts. Check coverage before printing.
Additional Tips & Tricks
Please see Additional Tips & Tricks section for TOUGH-GRY 10.
© by 3D Systems, Inc. All rights reserved. Specifications subject to change without notice. 3D Systems, the 3D Systems logo are registered trademarks and Figure 4 Standalone and Figure 4 are trademarks of 3D Systems, Inc. |
Rev. H, P/N 42-D114 |